The Button Smasher 3000 Works (After I Soldered the LEDs Backwards) (Classic Computing – Ep. 0x004)
The circuit boards I designed in KiCad finally showed up, so it’s time to solder them and find out whether they work. The parts are late, the store is out of flux, and the copper pads aren’t what I meant to order. What could go wrong?
Two boards get built, one controller gets surgery, and the breadboard rat’s nest gets a little smaller. Stick around for the final button test.
CHAPTERS 0:00 The rat’s nest, explained 1:38 Field trip: Surplus Gizmos 3:47 Way too many parts 4:12 Soldering straight to copper 5:40 Swapping in the Player 2 board 9:13 First test 10:22 Good news, bad news 12:17 Second test 13:26 Gutting the porcupine 15:33 Ribbon cable test 17:11 Hot glue ate a pin 18:00 Twelve buttons 19:37 Coming up next
WHAT’S IN THE BOX
- Raspberry Pi 4 and the Button Smasher 3000 Pi HAT (designed in KiCad: https://www.kicad.org )
- 2N3904 NPN transistors, resistors, LEDs and headers from DigiKey: https://www.digikey.com
- Boards fabricated by JLCPCB: https://jlcpcb.com
- Surplus Gizmos: https://www.surplusgizmos.com
- Previously: designing the board (Classic Computing – Ep. 0x003) and the original breadboard build (Classic Computing – Ep. 0x002)
Have you ever soldered something in backwards? How many times before you noticed? Tell me in the comments.
If you want to see where this goes next, subscribe so you don’t miss it.
❤️ Patreon: https://www.patreon.com/cw/Questionable_Commands
#RaspberryPi #PCB #SNES #Soldering #KiCad #RetroGaming