My First PCB: Turning the SNES Button Smasher into a Pi HAT (Classic Computing - Ep. 0x003)
Table of Contents
Description
In the previous Classic Computing video, I wired a Raspberry Pi to a breadboard full of transistors so it could press the buttons on a real SNES controller. It works, but it is also a rat’s nest. So I fired up KiCad to take the Button Smasher 3000 from breadboard to an actual PCB.
I had watched a couple of tutorials so I wouldn’t be starting out as a complete idiot. Twelve transistors, twenty-four resistors and twelve LEDs laid out to mimic the buttons on a controller, plus a lot of squinting at a schematic. It took a lot of squinting at a schematic. Then came the part that intimidated me: laying out the board, which may have cost me some of my sanity.
⏱ Chapters 0:00 The contraption so far 0:39 All aboard the struggle bus 1:29 New project: Button Smasher 3000 3:06 Twelve transistors, one phone photo 4:43 Resistors (I read them wrong) 6:09 Grounds, wires and a mystery header 9:12 Base pins meet the Pi GPIO 10:51 Coffee, a wrong pin, and the rules checker 11:52 An LED for every button 14:48 Assigning footprints 17:57 Into the PCB editor 19:29 Standing the resistors up 20:52 Six hours later 21:38 The 3D render and the one takeaway 23:41 1000 subscribers! 24:07 Bloopers
📦 What’s in the box • KiCad 10: https://www.kicad.org/ • Raspberry Pi 4 (the brains, from last episode): https://www.raspberrypi.com/products/raspberry-pi-4-model-b/ • 2N3904 NPN transistors, 1k and 330 ohm resistors, 3 mm LEDs, a 2x7 IDC box header • A clone SNES and a real SNES controller • Previous episode (the breadboard build): https://youtu.be/f2cLBiSWRyY • KiCad tutorials that helped me get started: – KiCad 10 Made Simple, From Zero Experience to a Real PCB (EmbeddedU): https://www.youtube.com/watch?v=g3vxpdG1chs – Beginner’s Guide to KiCad (made by morten): https://www.youtube.com/watch?v=lTD16PAXeAs
What was your first PCB? And if you’ve never designed one, what would you make? Let me know in the comments.
If you enjoyed this, consider subscribing. We just crossed 1000 of you, which still feels unreal. Thank you.
❤️ Patreon: https://www.patreon.com/cw/Questionable_Commands
#KiCad #PCB #RaspberryPi #SNES #homelab #electronics #maker